Treatment method for deviation of running time of baffle belt

When the conveyor is running, the baffle belt deviation is one of the common faults of Zui.

There are many reasons for deviation, the main reason is the low installation accuracy and poor daily maintenance.

1. During the installation process, the head and tail rollers and the intermediate rollers should be on the same center line as possible and parallel to each other to ensure that the mesh belt is not biased or less biased. In addition, the strap joints should be correct and the circumferences on both sides should be the same. This can effectively prevent the belt from running off.

2. In the course of use, if there is a deviation in the baffle belt , the following checks should be made to determine the cause and make adjustments.

The parts and treatment methods for checking the deviation of the belt belt are:

1 Check the misalignment of the transverse centerline of the roller and the longitudinal centerline of the belt conveyor. If the non-coincidence value exceeds 3 mm, it should be adjusted with the long mounting holes on both sides of the roller set. The specific method is which side of the mesh belt is biased, which side of the roller set moves forward in the direction in which the mesh belt advances, and the baffle mesh belt or the other side moves backward.

2 Check the deviation of the two planes of the head and tail frame mounting housing. If the deviation between the two planes is greater than 1 mm, the two planes should be adjusted in the same plane. The adjustment method of the head roller is: if the mesh belt runs away from the right side of the drum, the bearing seat on the right side of the drum should move forward or the left bearing seat moves backward; if the mesh belt runs away from the left side of the drum, then The bearing housing on the left side of the drum should move forward or the right bearing housing moves back. The tail roller is adjusted in the opposite way to the head roller.

3 Check the position of the material on the mesh belt. The material is not centered on the cross section of the mesh belt, which will cause the mesh belt to run off. If the material is on the right side, the belt runs to the left and vice versa. The material should be centered as much as possible when in use. To reduce or avoid such a belt deviation, the baffle can be added, and the baffle belt changes the direction and position of the material.